FREERIDER X2 HUB, Manual

18. Maintenance

17

18.1 Setting Brake System Front and rear wheel disc brake
The optimum braking performance is achieved by adjusting the brake pads regularly.
To do this, release the brake saddle from the bracket by releasing the two bus screws.

After the two mountings have been adjusted accordingly, the brake saddle can be
 mounted back on the bracket with the two inlet screws.

Work to be done

14 -day

Monthly

If needed

Before

departure

All screws and clamps and

Check couplings on a fixed seat and if 

necessary. Adjust.

Check chain tension, if applicable.

Adjust; clean the chain and use chain oil.

Point 4.
Check steering head bearings for correct 

seat, if applicable. adjusting and greasing.

Point 2.

Brake system functional test, if applicable. 

Adjust, check brake linings, see paragraph 1.

Check tyre air pressure and if necessary. 

correct

test drive after maintenance,Control of 

operational safety

Load battery with the supplied charger

Check and adjust cable trains

Check and tighten buffer bearings. Point 3.

The two brake linings should 

then be in the visible area. The 

distance between the two 

layers should correspond to the 

strength of the brake pad 

(approx. 2.5mm).

To adjust the inner brake lining, 

use the bus key and turn the 

bus screw clockwise until the 

lining has reached the appropri-

ate position.

To align the brake pedal in the 

middle around the brake disc, 

you can loosen the two black 

screws slightly and then move 

along the long hole to adjust the 

position exactly.