Chapter 29 1024 KByte Flash Module (S12XFTM1024K5V2)
MC9S12XE-Family Reference Manual , Rev. 1.19
1158
Freescale Semiconductor
CCIF, ACCERR, and FPVIOL bits are readable and writable, MGBUSY and MGSTAT bits are readable
but not writable, while remaining bits read 0 and are not writable.
29.3.2.8
Flash Error Status Register (FERSTAT)
The FERSTAT register reflects the error status of internal Flash operations.
Offset Module Base + 0x0006
7
6
5
4
3
2
1
0
R
CCIF
0
ACCERR
FPVIOL
MGBUSY
RSVD
MGSTAT[1:0]
W
Reset
1
0
0
0
0
0
0
(1)
1. Reset value can deviate from the value shown if a double bit fault is detected during the reset sequence (see
0
= Unimplemented or Reserved
Figure 29-11. Flash Status Register (FSTAT)
Table 29-17. FSTAT Field Descriptions
Field
Description
7
CCIF
Command Complete Interrupt Flag
— The CCIF flag indicates that a Flash command has completed. The
CCIF flag is cleared by writing a 1 to CCIF to launch a command and CCIF will stay low until command
completion or command violation.
0 Flash command in progress
1 Flash command has completed
5
ACCERR
Flash Access Error Flag
— The ACCERR bit indicates an illegal access has occurred to the Flash memory
caused by either a violation of the command write sequence (see
) or issuing an illegal Flash
command or when errors are encountered while initializing the EEE buffer ram during the reset sequence.
While ACCERR is set, the CCIF flag cannot be cleared to launch a command. The ACCERR bit is cleared by
writing a 1 to ACCERR. Writing a 0 to the ACCERR bit has no effect on ACCERR.
0 No access error detected
1 Access error detected
4
FPVIOL
Flash Protection Violation Flag
—The FPVIOL bit indicates an attempt was made to program or erase an
address in a protected area of P-Flash memory during a command write sequence. The FPVIOL bit is cleared
by writing a 1 to FPVIOL. Writing a 0 to the FPVIOL bit has no effect on FPVIOL. While FPVIOL is set, it is not
possible to launch a command or start a command write sequence.
0 No protection violation detected
1 Protection violation detected
3
MGBUSY
Memory Controller Busy Flag
— The MGBUSY flag reflects the active state of the Memory Controller
.
0 Memory Controller is idle
1 Memory Controller is busy executing a Flash command (CCIF = 0) or is handling internal EEE operations
2
RSVD
Reserved Bit
— This bit is reserved and always reads 0
.
1–0
MGSTAT[1:0]
Memory Controller Command Completion Status Flag
— One or more MGSTAT flag bits are set if an error
is detected during execution of a Flash command or during the Flash reset sequence. See
,” and
” for details.
Because
of
an
order
from
the
United
States
International
Trade
Commission,
BGA-packaged
product
lines
and
part
numbers
indicated
here
currently
are
not
available
from
Freescale
for
import
or
sale
in
the
United
States
prior
to
September
2010:
S12XE
products
in
208
MAPBGA
packages
