Chapter 24 128 KByte Flash Module (S12XFTM128K2V1)
MC9S12XE-Family Reference Manual , Rev. 1.19
872
Freescale Semiconductor
24.4.2.7
Erase All Blocks Command
The Erase All Blocks operation will erase the entire P-Flash and D-Flash memory space including the EEE
nonvolatile information register.
Upon clearing CCIF to launch the Erase All Blocks command, the Memory Controller will erase the entire
Flash memory space and verify that it is erased. If the Memory Controller verifies that the entire Flash
memory space was properly erased, security will be released. During the execution of this command
(CCIF=0) the user must not write to any Flash module register. The CCIF flag will set after the Erase All
Blocks operation has completed.
Table 24-44. Program Once Command Error Handling
Register
Error Bit
Error Condition
FSTAT
ACCERR
Set if CCOBIX[2:0] != 101 at command launch
Set if command not available in current mode (see
)
Set if an invalid phrase index is supplied
Set if the requested phrase has already been programmed
(1)
1. If a Program Once phrase is initially programmed to 0xFFFF_FFFF_FFFF_FFFF, the Program Once command will
be allowed to execute again on that same phrase.
FPVIOL
None
MGSTAT1
Set if any errors have been encountered during the verify operation
MGSTAT0
Set if any non-correctable errors have been encountered during the verify
operation
FERSTAT
EPVIOLIF
None
Table 24-45. Erase All Blocks Command FCCOB Requirements
CCOBIX[2:0]
FCCOB Parameters
000
0x08
Not required
Table 24-46. Erase All Blocks Command Error Handling
Register
Error Bit
Error Condition
FSTAT
ACCERR
Set if CCOBIX[2:0] != 000 at command launch
Set if command not available in current mode (see
)
FPVIOL
Set if any area of the P-Flash memory is protected
MGSTAT1
Set if any errors have been encountered during the verify operation
(1)
1. As found in the memory map for FTM256K2.
MGSTAT0
Set if any non-correctable errors have been encountered during the verify
operation
FERSTAT
EPVIOLIF
Set if any area of the buffer RAM EEE partition is protected
Because
of
an
order
from
the
United
States
International
Trade
Commission,
BGA-packaged
product
lines
and
part
numbers
indicated
here
currently
are
not
available
from
Freescale
for
import
or
sale
in
the
United
States
prior
to
September
2010:
S12XE
products
in
208
MAPBGA
packages
