MC68332
SYSTEM INTEGRATION MODULE
USER’S MANUAL
4-5
4.2.7 Bus Monitor
The internal bus monitor checks data and size acknowledge (DSACK) or autovector
(AVEC) signal response times during normal bus cycles. The monitor asserts the in-
ternal bus error (BERR) signal when the response time is excessively long.
DSACK and AVEC response times are measured in clock cycles. Maximum allowable
response time can be selected by setting the bus monitor timing (BMT) field in the sys-
tem protection control register (SYPCR).
shows the periods allowed.
The monitor does not check DSACK response on the external bus unless the CPU32
initiates a bus cycle. The BME bit in SYPCR enables the internal bus monitor for inter-
nal to external bus cycles. If a system contains external bus masters, an external bus
monitor must be implemented and the internal-to-external bus monitor option must be
disabled.
When monitoring transfers to an 8-bit port, the bus monitor does not reset until both
byte accesses of a word transfer are completed. Monitor time-out period must be at
least twice the number of clocks that a single byte access requires.
4.2.8 Halt Monitor
The halt monitor responds to an assertion of the HALT signal on the internal bus. Refer
to
for more information. Halt monitor reset can be inhibited
by the halt monitor (HME) bit in SYPCR.
4.2.9 Spurious Interrupt Monitor
During interrupt exception processing, the CPU32 normally acknowledges an interrupt
request, recognizes the highest priority source, and then acquires a vector or re-
sponds to a request for autovectoring. The spurious interrupt monitor asserts the in-
ternal bus error signal (BERR) if no interrupt arbitration occurs during interrupt
exception processing. The assertion of BERR causes the CPU32 to load the spurious
interrupt exception vector into the program counter. The spurious interrupt monitor
for further information. For detailed infor-
mation about interrupt exception processing, refer to
.
4.2.10 Software Watchdog
The software watchdog is controlled by the software watchdog enable (SWE) bit in
SYPCR. When enabled, the watchdog requires that a service sequence be written to
software service register SWSR on a periodic basis. If servicing does not take place,
the watchdog times out and asserts the reset signal.
Table 4-2 Bus Monitor Period
BMT
Bus Monitor Time-out Period
00
64 System Clocks
01
32 System Clocks
10
16 System Clocks
11
8 System Clocks
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
.
..
