Chapter 8 Timer Module (TIM16B8CV3) Block Description
S12ZVHY/S12ZVHL Family Reference Manual Rev. 1.05
Freescale Semiconductor
319
Writing to the timer port bit of an output compare pin does not affect the pin state. The value written is
stored in an internal latch. When the pin becomes available for general-purpose output, the last value
written to the bit appears at the pin.
When TCRE is set and TC7 is not equal to 0, then TCNT will cycle from 0 to TC7. When TCNT reaches
TC7 value, it will last only one Bus cycle then reset to 0.
Note: in
,if PR[2:0] is equal to 0, one prescaler counter equal to one Bus clock
Figure 8-31. The TCNT cycle diagram under TCRE=1 condition
8.4.3.1
OC Channel Initialization
The internal register whose output drives OCx can be programmed before the timer drives OCx. The
desired state can be programmed to this internal register by writing a one to CFORCx bit with TIOSx,
OCPDx and TEN bits set to one.
Set OCx: Write a 1 to FOCx while TEN=1, IOSx=1, OMx=1, OLx=1 and OCPDx=1
Clear OCx: Write a 1 to FOCx while TEN=1, IOSx=1, OMx=1, OLx=0 and OCPDx=1
Setting OCPDx to zero allows the internal register to drive the programmed state to OCx. This allows a
glitch free switch over of port from general purpose I/O to timer output once the OCPDx bit is set to zero.
8.4.4
Pulse Accumulator
The pulse accumulator (PACNT) is a 16-bit counter that can operate in two modes:
Event counter mode — Counting edges of selected polarity on the pulse accumulator input pin, PAI.
Gated time accumulation mode — Counting pulses from a divide-by-64 clock. The PAMOD bit selects the
mode of operation.
The minimum pulse width for the PAI input is greater than two Bus clocks.
TC7
0
1
-----
TC7-1
TC7
0
TC7 event
TC7 event
prescaler
counter
1 Bus
clock
