Chapter 13 Serial Peripheral Interface (S12SPIV5)
S12ZVHY/S12ZVHL Family Reference Manual Rev. 1.05
520
Freescale Semiconductor
13.3.2.2
SPI Control Register 2 (SPICR2)
Read: Anytime
Write: Anytime; writes to the reserved bits have no effect
1
SSOE
Slave Select Output Enable
— The SS output feature is enabled only in master mode, if MODFEN is set, by
asserting the SSOE as shown in
. In master mode, a change of this bit will abort a transmission in
progress and force the SPI system into idle state.
0
LSBFE
LSB-First Enable
— This bit does not affect the position of the MSB and LSB in the data register. Reads and
writes of the data register always have the MSB in the highest bit position. In master mode, a change of this bit
will abort a transmission in progress and force the SPI system into idle state.
0 Data is transferred most significant bit first.
1 Data is transferred least significant bit first.
Table 13-3. SS Input / Output Selection
MODFEN
SSOE
Master Mode
Slave Mode
0
0
SS not used by SPI
SS input
0
1
SS not used by SPI
SS input
1
0
SS input with MODF feature
SS input
1
1
SS is slave select output
SS input
Module Base +0x0001
7
6
5
4
3
2
1
0
R
0
XFRW
0
MODFEN
BIDIROE
0
SPISWAI
SPC0
W
Reset
0
0
0
0
0
0
0
0
= Unimplemented or Reserved
Figure 13-4. SPI Control Register 2 (SPICR2)
Table 13-2. SPICR1 Field Descriptions (continued)
Field
Description
