ColdFire Flash Module (CFM)
MCF52235 ColdFire® Integrated Microcontroller Reference Manual, Rev. 6
Freescale Semiconductor
17-27
Mass Erase
The mass erase operation erases all flash memory addresses using an embedded algorithm.
An example flow to execute the mass erase command is shown in
. The mass erase command
write sequence is as follows:
1. Write to any flash memory address to start the command write sequence for the mass erase
command. The specific address and data written during the mass erase command write sequence
is ignored.
2. Write the mass erase command, $41, to the CFMCMD register.
3. Clear the CBEIF flag by writing a 1 to CBEIF to launch the mass erase command.
If any flash logical sector is protected, the PVIOL flag in the CFMUSTAT register sets during the
command write sequence and the mass erase command does not launch. After the mass erase command
has successfully launched, the CCIF flag in the CFMUSTAT register sets after the mass erase operation
has completed, unless a new command write sequence has been buffered.
Because
of
an
order
from
the
United
States
International
Trade
Commission,
BGA-packaged
product
lines
and
part
numbers
indicated
here
currently
are
not
available
from
Freescale
for
import
or
sale
in
the
United
States
prior
to
September
2010:MCF52234CVM60,
MCF52235CVM60
