Signal Descriptions
MCF52235 ColdFire® Integrated Microcontroller Reference Manual, Rev. 6
Freescale Semiconductor
2-9
2.3
Reset Signals
describes signals that are used to reset the chip or as a reset indication.
2.4
PLL and Clock Signals
describes signals that are used to support the on-chip clock generation circuitry.
2.5
Mode Selection
describes signals used in mode selection.
2.6
External Interrupt Signals
describes the external interrupt signals.
Table 2-2. Reset Signals
Signal Name
Abbreviation
Function
I/O
Reset In
RSTI
Primary reset input to the device. Asserting RSTI immediately resets
the CPU and peripherals.
I
Reset Out
RSTO
Driven low for 512 CPU clocks after the reset source has deasserted
and PLL locked.
O
Table 2-3. PLL and Clock Signals
Signal Name
Abbreviation
Function
I/O
External Clock In
EXTAL
Crystal oscillator or external clock input.
I
Crystal
XTAL
Crystal oscillator output.
O
Clock Out
CLKOUT
This output signal reflects the internal system clock.
O
Table 2-4. Mode Selection Signals
Signal Name
Abbreviation
Function
I/O
Reset Configuration
RCON
The serial flash programming mode is entered by asserting the
RCON pin (with the TEST pin negated) as the chip comes out of
reset. During this mode, the EzPort has access to the flash memory
which can be programmed from an external device.
Test
TEST
Reserved for factory testing only and in normal modes of operation
should be connected to VSS to prevent unintentional activation of
test functions.
I
Table 2-5. External Interrupt Signals
Signal Name
Abbreviation
Function
I/O
External Interrupts
IRQ[15:1]
External interrupt sources.
I
Because
of
an
order
from
the
United
States
International
Trade
Commission,
BGA-packaged
product
lines
and
part
numbers
indicated
here
currently
are
not
available
from
Freescale
for
import
or
sale
in
the
United
States
prior
to
September
2010:MCF52234CVM60,
MCF52235CVM60
