MPC8572E Advanced Mezzanine Card Hardware Getting Started Guide, Rev. 1.0
8
Freescale Semiconductor
Connecting JTAG Debugging Tools to the Board
4
Connecting JTAG Debugging Tools to the Board
Figure 4
illustrates an example of how to connect a JTAG debugger to the MPC8572EAMC. The USB tap
debugging tool enables the CodeWarrior software IDE to work with the MPC8572EAMC board.
1. Connect the JTAG debugger unit to the JTAG 16-pin connector (J4).
2. Connect USB cable from Host PC (with CodeWarrior Power Architecture™ tools installed on it)
to CodeWarrior USB Tap.
Figure 4
illustrates Freescale’s CodeWarrior debugger connected to the
MPC8572EAMC. Note the orientation of pin 1 (red edge of ribbon cable) with pin 1 on J4.
3. Switch on power to the board.
4. Check for completion of the reset sequence (see step 3) and power indicator on USB Tap.
5. Continue as per standard CodeWarrior instructions.
a) Contact your local FAE for the correct JTAG configuration file.
Figure 4. USB TAP Connection to Header J4
5
Front Panel Connectivity
Figure 5
shows the different front panel connections. P1 provides a RJ45 10/100 Ethernet port. The final
front panel connector P3 provides two high speed Gigabit Ethernet connections. Serial connectivity for
General debug POR CPLD
LD501
Yellow
User config #2
User config #2
General debug POR CPLD
LD503
Yellow
User config #3
User config #3
Table 5. LED Operation (continued)
Description
Ref
Color
LED On
LED Off
