Power the
Board
To power up the collector board, plug the
Kinetis KWIKSTIK board into a PC using
the USB cable provided. Either of the
micro USB ports on the Kinetis KWIKSTIK
will work.
Confirm Pairing of
the Boards
The LCD screen on the KWIKSTIK board
will illuminate after it is powered from
USB cable and will display a numeric
value which is being transmitted from the
sender representing a heart rate monitor.
Quick Start Guide
4
Check the TWRPI-
BLE-SS1 Modules
The demo consists of two TWRPI-BLE-
SS1 modules. Both modules are pre-
assembled. One module (collector) is
plugged into the Kinetis KWIKSTIK and
the other module (sender) is plugged into
the RF-BAT board.
Insert the
Battery
Insert the CR2032 coin cell into the
battery slot of the sender on the RF-BAT
board. The device will remain powered
and will be transmitting until the jumper
is removed.
Note:
Please ensure that the coin cell battery
voltage is at least 2.9 V.
Step-by-Step Installation Instructions
1
3
4
2