A�er the bike has been properly assembled according to the assembly video, all components are secured
correctly, a cer�fied, reputable mechanic has checked the assembly, and you have read this ensure manual,
turn on the bike and select a pedal assist level following the steps below:
1. Turn on the bike. With the ba�ery locked in place. Locate the LCD display controller (near the le�
handlebar grip). Hold down the
bu�on for approximately 2 seconds un�l power is delivered to the
LCD display and turn on.
2. Turn on the front light if needed or desired. Once the ba�ery is on, long press
bu�on.
3. Select the desired level of pedal assistance (PAS) between level 0 through 5 using the + and -
on the display controller. Level 1 corresponds to the lowest level of pedal assistance, and level 5 corresponds
to the highest level of pedal assistance. Level 0 indicates pedal assistance is inac�ve. Start in PAS level 0 or 1
and adjust from there.
4. Begin riding carefully. With the proper safety gear and rider knowledge, you may now operate your bike.
On a flat surface, in a low gear (1 or 2), most riders should be able to begin pedaling the bike with pedal
assist level 0 or 1. You may also use the thro�le to accelerate and maintain your desired speed.
5. The thro�le is used by slowly and carefully rota�ng the thro�le backward toward the rider. Do not use
the thro�le unless you are on the bike.
Do not use the thro�le while dismounted. Avoid accidental applica�on
of the thro�le while dismounted; any�me you are moving the bike while
dismounted, ensure the bike is powered off to prevent accidental
applica�on of the thro�le.
Start-Up Procedure
�
15
