995066 - Revision A
Page 32 of 41
9.11 – Leg – (LH Leg and RH Leg)
Within this section it will explain the correct procedure on removing and reinstalling the legs of the
Stand Aid, images refer to one leg only but same applies to both.
Removal
Step 1 – Remove the Leg Actuator Cable. (Refer to section 9.2.3)
Step 2 – Remove the Leg Actuator. (Refer to section 9.6)
Step 3 - Place the Stand Aid on its side for easier service – Gently rest it on its side to avoid
damage such as paint scratching.
Step 4 – Remove the Leg Rod Assembly. (Refer to section 9.8)
Step 5 - Remove the Front and Rear Castor where applicable. (See section 9.9 and 9.10)
Step 6 – Using two 5mm Allen Keys, remove one of the screws from the Pivoting Boss.
Step 7 – Using the Allen Key, rotate the Pivoting Boss inside the Leg, until the hole aligns
with the hole on the side of the Leg. Use a tool such as a 3mm Allen key and insert into the
Boss as shown in the image to allow the Allen Key to remove the screw.
Step 8 – Remove the Leg from the Frame.
Refitting / Replacement
Step 9 - Refitting is a reversal of the removal process noting the following points:
A)
Apple Loctite to the screws when refitting.
