995066 - Revision A
Page 40 of 41
Refitting / Replacement
Step 8 - Refitting is a reversal of the removal process noting the following point:
A)
When refitting, ensure to place a saddle washer between the Frame and Bracket for
each fixing.
B)
Ensure the Control Bracket is fitted in the correct orientation, as shown in step 5.
9.16 – Frame
Within this section it will explain the correct procedure on removing and reinstalling the
Frame for servicing procedures or replacement.
Removal
Step 1 – Remove Battery from the Control Box. (Refer to section 9.1)
Step 2 – Remove all the Cabling/leads from the Control Box. (Refer to section 9.2)
Step 3 – Remove the Control Box from the product. (Refer to section 9.3)
Step 4 - Remove the Attachment Bracket from the Frame. (Refer to section 9.4)
Step 5 – Remove the Lift Actuator from the Stand Aid. (Refer to section 9.5)
Step 6 – Remove the Leg Actuator from the Frame. (Refer to section 9.6)
Step 7 – Remove the Upper Assembly from the Frame. (Refer to section 9.7)
Step 8 – Remove the Leg Rod Assembly from the Frame. (Refer to section 9.8)
Step 9 – Remove the Front Castors from the Legs. (Refer to section 9.9)
Step 10 – Remove the Rear Castors from the Frame. (Refer to section 9.10)
Step 11 – Remove the Legs from the Frame. (Refer to section 9.11)
Step 12 – Remove the Leg Bearing Assembly from the Frame. (Refer to section 9.12)
Step 13 – Remove the Foot Tray from the Frame. (Refer to section 9.13)
Step 14 – Remove the Knee Pad from the Frame. (Refer to section 9.14)
Step 15 – Remove the Control Bracket from the Frame. (Refer to section 9.15)
Refitting / Replacement
Step 16 - Refitting is a reversal of the removal process.
