Using the Key Fob
Key Fob Use
DANGER
Do not ingest the key fob battery. The button cell
battery in this key fob is a chemical burn hazard.
Always keep the key fob and button cell batteries
away from children.
Always safely dispose of used batteries.
If the button cell battery in this key fob is
swallowed, it can cause severe internal burns
within two hours and can lead to death. If you
think a battery might have been swallowed or
otherwise placed inside any part of the body,
seek immediate medical attention.
If the battery compartment does not close
securely, stop using the key fob.
Keyless entry is standard on eCascadia vehicles.
The key fob can be used to remotely lock and unlock
the doors, start and end the pre-trip light check, and
open the side windows. See
•
To lock both doors, press the lock button.
•
To unlock both doors, press the unlock button.
•
To open the side windows, press the unlock
button for three seconds.
•
To start or end the pre-trip light check, press
the lamp check button.
Key Fob Programming
A maximum of four fobs can be programmed to work
on one vehicle. Whenever a new fob is needed, all
existing fobs must be reprogrammed at the same
time. Any existing fobs that were previously
programmed will no longer work on the vehicle
unless they are all reprogrammed at the same time.
To have the key fobs programmed, take the vehicle
to an authorized Freightliner dealer or service facility.
Specifications
This system consists of a key fob that uses a radio
frequency link for communication between the fob
and the vehicle.
Opening the Doors
The physical key can be used to lock and unlock the
doors and activate the electrical system.
IMPORTANT: Record the key number so, if
needed, a duplicate key can be made.
NOTE: The cab door locks can be operated
when the doors are open.
To unlock the driver’s door from outside the cab,
insert the key in the lock and turn it one-quarter turn
clockwise. To remove the key, turn it
counterclockwise to the original position. Pull the
door pull handle, shown in
, to open the door.
To unlock the passenger’s door from outside the cab,
insert the key in the lock and turn it one-quarter turn
counterclockwise. Turn the key clockwise to the
original position to remove it.
To lock a door from outside the cab, close the door if
it is open, insert the key in the lock, and turn it in the
direction opposite to the unlocking direction
(counterclockwise for the driver’s door, clockwise for
the passenger’s door).
To lock either door from inside the cab, push the lock
button downwards. See
To open the door from the inside, lift up on the door
lever. This will unlatch the door whether or not it is
locked.
To unlock the door without unlatching it, pull the lock
button upwards.
f546880a
10/23/2019
3
2
1
1.
Lock Button
2.
Unlock Button
3.
Lamp Check Button
Fig. 2.1, Key Fob
Vehicle Access
2.1
Summary of Contents for PX113064S T 2016
