Descriptions of LEFT and RIGHT are from the point of view of standing
behind the equipment facing the front
12
ASSEMBLY DIAGRAM 7
USE A PARTNER TO HELP WITH THIS STEP
REMEMBER: Only hand tighten all nuts and bolts until whole
&&Ͳ
X
ϰ
is assembled
1.
Attach the FRONT COVER (30) to the FRONT PRESS BASE (9) using six RIVETS (70). Insert a BUSHING (25) into each
side of the base.
(See the exploded diagram for more detail, skip this step if pre-assembled)
2.
Insert a HANDLE GRIP (35) into each side of the FRONT PRESS (39). Insert
an END CAP (61) to
the end of each handle
and an END CAP (64) on the ends of the FRONT PRESS (39)
. Insert a MAGNET (75) into each rear side of the BUTTERFLY
(39)
(See the exploded diagram for more detail, skip this step if pre-assembled)
3.
Insert a BUSHING (54) into each side of the axel hole near the front of the UPPER FRAME (4). Ensuring correct
orientation, position the FRONT PRESS BASE (9) over the axel hole.
4.
Slide the UPPER AXEL (31) through the FRONT PRESS BASE (9) and the UPPER FRAME (4) from left to right. Connect
using a HEX BOLT M10X16 (98) and a WASHER (93)
5.
Ensuring correct orientation, position the FRONT PRESS (39) over the holes at the base
of the FRONT PRESS BASE (9)
6.
Slide the MID AXEL (12) through the FRONT PRESS (39) and the FRONT PRESS BASE (9). Connect using two HEX BOLT
M10X16 (98) and two WASHER (93). Insert two ALLEN BOLT M8X16 (121) to the rear holes on the BUTTERFLY (39)
7.
Connect a LOCK KNOB (33) through the upper right side of the FRONT PRESS (39)
8.
Behind each butterfly handle, connect vertically upward a SHORT CONNECTABLE CABLE (44), using a HEX BOLT
M10X25 (100), two WASHER10 (92) and an AIRCRAFT NUT M10 (97) on each side.
