Descriptions of LEFT and RIGHT are from the point of view of standing
behind the equipment facing the front
18
ASSEMBLY DIAGRAM 1
USE A PARTNER TO HELP WITH THIS STEP
REMEMBER: Only hand tighten all nuts and bolts until whole
&&Ͳ
X
ϰ
is assembled
(HINT: Work your way from one end of the cable to the other, connecting one pulley at a time and ensuring
everything is positioned correctly before continuing. Ensure the cable retainers are all correctly angled)
1.
IMPORTANT:
If you undo the end of the PULLCABLE (40) during assembly, it is very important to ensure that you
securely re-tighten the nuts at the ends of the cable before use . Use the diagram as a reference.
2.
Position one end of the cable in the pulley bracket on the front of the LEG DEVELOPER (26)
3.
Insert a PULLEY (79) into the bracket, ensuring the cable runs under the pulley from front to back. Attach using a HEX
BOLT M10X50 (102), with a WASHER10 (92), a CABLE RETAINER (86), and a CABLE RETAINER BUSHING (85) on each
outer side of the bracket. Secure with an AIRCRAFT NUT M10 (97)
4.
Draw the cable backward, through the pulley bracket at the front of the BASE FRAME (13)
DIAGRAM D
5.
Insert a PULLEY (79) into the bracket, ensuring the cable runs under the pulley. Attach using a HEX BOLT M10X55
(103), with a WASHER10 (92), a CABLE RETAINER (86), and a CABLE RETAINER BUSHING (85) on each outer side of the
bracket. Secure with an AIRCRAFT NUT M10 (97)
6.
Draw the cable backward, through the pulley bracket in the middle of the BASE FRAME (13)
DIAGRAM C
7.
Insert a PULLEY (79) into the bracket, ensuring the cable runs under the pulley. Attach using a HEX BOLT M10X55
(103), with a WASHER10 (92), a CABLE RETAINER (86), and a CABLE RETAINER BUSHING (85) on each outer side of the
bracket. Secure with an AIRCRAFT NUT M10 (97)
8.
Draw the cable upward to the ADJUSTABLE PULLEY BRACKET (17) at the top of the FRONT VERTICAL FRAME (3)
DIAGRAM A
. Insert a PULLEY (79) into a lower bolt hole, ensuring the cable runs over the pulley from rear to front.
Attach using a HEX BOLT M10X55 (103), with a WASHER10 (92), a CABLE RETAINER (86), and a CABLE RETAINER
BUSHING (85) on each outer side of the bracket. Secure with an AIRCRAFT NUT M10 (97)
9.
Draw the cable downward into the pulley bracket on top of the BUTTERFLY SUPPORT (21)
DIAGRAM B
10. Insert a PULLEY (79) into the bracket, ensuring the cable runs under the pulley from rear to front. Attach using a HEX
BOLT M10X55 (103), with a WASHER10 (92), a CABLE RETAINER (86), and a CABLE RETAINER BUSHING (85) on each
outer side of the bracket. Secure with an AIRCRAFT NUT M10 (97)
11. Draw the cable upwards and forward through the slit in the FRONT VERTICAL FRAME (3)
12. Insert a PULLEY (79) into the slit, ensuring the cable runs over the pulley. Attach using a HEX BOLT M10X65 (104), two
PULLEY BUSHING (83) and an AIRCRAFT NUT M10 (97)
