4
SKIP ONE
MANUAL
4
SKIP ONE
MANUAL
ASSEMBLING AND DISSASSEMBLING THE TRIKE
The trike is assembled in reverse order of its disassembly
1. Place rear wheels into the axle and lock with shaft
locking pin (figure 4)
2. Place seat brace into fixture (figure 2) and secure by
means of ball locking pin
3. Secure the retainer sleeve for locking the front
brace (figure 1) by means of ball locking pin.
4. Hook in seat.
5. Hook engine into fixture and secure with
straps (figure 5, 6)
6. Place throttle handle into fixture (figure 7)
First of all, the front brace is separated from the roll bar.
To do so, the sleeve which is held by the two ball locking
pins is pulled down. See figure 1.
Figure 3 shows the collapsed trike. The trike has a height of
1400 mm, in a collapsed state of 750 mm.
The seat brace is also held by a ball locking pin.
If it is removed, the trike can be collapsed as a whole.
See figure 2 and 3 in this regard.
Figure 1
Figure 2
Figure 3
