15
EN
ELECTRICAL INSTALLATION
IMPORTANT:
The fan should only be used in conjunction with fixed wiring.
Before starting any kind of electrical work, live cables must be disconnected.
1.
Press the two clamps on to the base of the fan (see Figure 2) and remove the cover from
the chassis.
2.
The fans in the Fresh F100 series can be installed so that the cables are concealed
(Figure 4) or exposed (Figure 5). Assembly, see previous page.
Open the internal cover (X) to access the terminal block electrical connection.
3.
The fans are intended for connection to 220-240V 50/60Hz. (power 7,5W, IPX5)
The fans are class II, double-insulated products, and SHOULD NOT be earthed.
Select and follow the appropriate wiring diagram. (Fig. 6 or 7).
Fig. 6 = Wiring diagram for F100, Fig. 7 = Wiring diagram for F100 T and TH
Check that all connections have been made correctly and properly.
Make sure that the impeller rotates and is free of obstacles.
4.
Replace the fan cover, making sure the hooks lock the cover securely.
Ls
N
L
Figure 5
Figure 4
Ls
N
L
N
L
N
L
Figure 6: F100
Figure 7: F100 T och TH
Fresh F100
Single speed fan. Controlled by
external switch (e.g. light switch).
Fresh F100 T:
Single-speed fan with overrun time.
The fan can be controlled via an external
power switch (SV2).
Or via a light switch (SV1) to terminal marked
Ls.
When SV1 is ”ON” - activated, the fan will
operate at full speed and continue to run
for a preset time after the switch has been
turned to ”OFF”.
Fresh F100 TH:
Two-speed fan with automatic
high-speed at high humidity levels.
Timer function with overrun time etc.
See the next page for more information.
SV1
SV2
L 1
N 2
LS 3
LS 3
L 1
N 2
(X)
(X)
220-240V ~ 50/60H
z
220-240V ~ 50/60H
z
