3
EN
Installation and electrical connection for
Fresh exhaust fans F100/F100 T/F100 TH.
IMPORTANT:
READ THESE INSTRUCTIONS BEFORE COMMENCING THE
INSTALLATION.
DO NOT install
this product in areas where
the following may be present or occur:
• The fan must not be used in an explosive environment or connected to a
flue gas duct, nor may it be used as a kitchen fan.
• Where corrosive or flammable gases, liquids or vapours may be present.
• At ambient temperatures above 40°C or below -5°C.
• Where there are potential obstacles that may restrict access to the fan.
SAFETY AND GUIDANCE NOTES
A.
Electrical installation must be carried out by a registered electrical
installation company.
All wiring must be in accordance with national
electrical installation rules for each country’s electrical regulations.
B. A device for disconnecting the fan must be included in the mains supply
network as specified in the national electrical installation rules.
C. Ensure that the mains supply (Voltage, Frequency) complies with the
rating label.
D. The fan is only intended for fixed installation.
E. When the fan is used to remove air from a room containing a fuel-
burning appliance, ensure that the air replacement is adequate for both
the fan and the fuel-burning appliance.
F. The fan should not be used where it is liable to be subject to direct water
spray for prolonged periods of time.
G. Where ducted fans are used to handle moisture-laden air, a conden
sation trap should be fitted. Horizontal ducts should be arranged to
slope slightly downwards away from the fan.
H.
According to standard EN 60335, the following should be taken into
account:
The appliance can be used by children aged eight and above, people
with impaired physical, sensory or mental capabilities or who lack of experi
ence and knowledge if they are supervised or have been instructed in the safe
use of the appliance and are aware of the risks involved.
I. Children must not play with the appliance.
Cleaning and maintenance must not be carried
out by children without supervision.
J. After installation, make sure that the
front cover is hooked into the fan
chassis as shown below.
