This appliance does not need an earth connection as it is double insulated. (Class II)
CONNECT THE LIVE SUPPLY TO
L
TERMINAL
CONNECT THE NEUTRAL TO ONE OF THE
N
TERMINALS - SEE BELOW:
TF200
Connect Mains Neutral to:
N3
for High Speed
N2
for Medium Speed
N1
for Low Speed
Maintenance and service
Switch off mains supply before making any
electrical connections. If in any doubt contact
a qualified electrician.
For any maintenance operation which is not simply
cleaning the exterior of the extractor fan, the casing
assembly must be taken out of its housing as indicated
in point 1 of the installation instructions. Then the two
reducer tubes (V) must be removed. (see Fig.14)
To remove casing assembly:
1. Loosen 8 screws (X)
2. Gently separate reduce cones (V)
from chassis.
The motor, fan and all the components must be
regularly inspected to ensure that they are not dirty
nor have suffered any damage. The frequency will
depend on its operating conditions.
During the maintenance sessions remove any dirt
collected on the fan blades and the internal parts of
the frame to avoid any imbalance in operation which
would lead to a reduction of the aerodynamic qualities
and possible damage to the motor.
Never submerge the appliance in water or in any
liquid. Do not use solvents to clean the appliance
The motor bearings need no maintenance.
X
V
X
V
X
Fig.14
RATING/ SPECIFICATIONS
For all electrical power and IP ratings refer to the fan
rating and wiring label.
IMPORTANT
Switch off mains supply before making any
electrical connections. If in any doubt contact a
qualified electrician. The appliance is not intended
for use by young children or infirm persons without
supervision.
Young children should be supervised to ensure that
they do not play with the appliance.
Precautions must be taken to avoid the backflow
of gases into the room from the open
flue of gas or other open-fire appliances
when mounted in outside windows or walls.
N2
N1
N2
N1
N2
N1
L
N
L
L
L
L
L
L
N
N
N
N3 Speed 3 MF200S only
N2 Speed 2
N1 Speed 1
Live
DO NOT USE
DO NOT USE
....
....
....
N3
N2
N1
L
DO NOT
USE
DO NOT
USE
TF100/ 125/ 150 mm
