THE PARAMETER MENU
Page 8
Service Manual Bake Star 3-5-8-10 intelligent form 9123665 rev. 03/2006
Parameter Function
Description
32
Temp zone limits
Presets for zone limits 0=large zone around setpoint, 3=small zone around setpoint
33
Temp fan mode
During the first 3 on/off cycles of the heating elements.
0 - normal fan mode
1 - heating elements stay off during fan off period
2 - ventilators remain on. No left right switching
34
Temp delta max
Maximum variation from setpoint
35
Temp inc factor
Gives more overshoot above setpoint
36
Temp dec factor
Gives more overshoot under setpoint
37
Over Heat
Not used
38
Temp corr.
Temperature measuring correction factor (0=off, 8=max), Used to reduce the fluctua-
tion in temperature caused by the fans changing direction
39
Time corr. min
Maximum time correction substracted
40
Time corr. max
Maximum time correction added
41
Time corr. floor
Amplification function for the bake-correction time. The higher the value the bigger
the correction.
42
E-temp alarm
Temperature of the electronics when an alarm sounds. The value is an indication of
the temperature. The higher the value the higher the temperature. Set range 600-850
43
Brightness
Set the brightness of the dislpay
44
Net address
Used to set communication between 2 ovens and a Time To Go display in the extrac-
tion hood. The master (connected to the extraction hood) uses address “0”.
45
Exh. fan on net
Set the control of the extrationhood motor of two stacked ovens via the network from
this oven (1=yes, 0=no)
46
Time to go disp.
Set the control of the Time To Go display via the network from this oven (1=yes,
0=no). When both ovens are set to “0 “ the shortest time is displayed.
47
Debug mode
Switch to debug mode to search for bugs in the software
48
Demo mode
Demo mode that deactivates the heating for demonstrating purposes
NOTE:
Parameters marked in grey should be changed with specific instructions from Fri-Jado
technical staff only!! Changing them without consulting Fri-Jado is at your own risk!!
