REMOVAL AND REPLACEMENT OF PARTS
Page 16
Service Manual Bake Basic form 9123763 rev. 03/2017
2
2
33
11
10
9
8
7
6
5
12
13
4
REPLACING THE HINGE OF A “DROP DOWN” DOOR
1) Remove the R side panel.
2) Disconnect the wires from the cera-
mic terminal block.
3) Pull out the flexible steel tube from
the grommet.
4) Remove the lower screw at each
hinge, if present. See arrow.
Put the door under a ± 35° angle and
lock both hinges with a pin (or screw or
screwdriver) with a 3 untill 4 mm dia-
meter.
5) Turn the door a little towards the
oven.
6) Lift it .
7) Pull the door out with a rotary mo-
tion.
8) Place the door on a clean table.
9) Put tension on the hinge with a wa-
terpump plier and pull out the pin.
10) Now release the spring tension.
11) Drill out the 4mm rivets at the
bottom side.
12) Remove the caps from the door-
handle.
13) Unscrew the doorhandle on both
sides.
