Page 28
Service Procedures
Service Manual Deli Multisserie form 9123560 rev. 02/2017
16.Disconnect the wiring from the 2 screw
terminals on the blower motor(s) and cut
the cable tie.
17.Remove the 4 nuts (M6 serrated) from the
aluminium motor-housing and carefully
take out the blower [50]. Repeat this if ne-
cessary with the other blower.
Refer to the concerning chapter to assemble
the blowers.
Keep blower motor and fan blade together!!
16
17
DISASSEMBLING THE SHAFT TRANSIT SPACER.
Remove the blowers and shaft seals accor-
ding prior procedure.
On the backside.
18. Remove the 4 bolts (M5x10) on the cor-
ners of the mounting plate. [255].
19. Stab loose the mounting plate with a
screw driver (or the like). (The spacer [254)
is sealed at the front side with sealant and
can possibly stick)
20. Pull the mountingplate with the spacer
out of the hole.
21. Remove the mounting plate from the
spacer (3 bolts M5x12).
18
19
20
21
