Page 29
Service Procedures
Service Manual Deli Multisserie form 9123560 rev. 02/2017
1. Clean and degrease the “old” spacer [254]
or take a new one.
2. Clean and degrease the contact-surface
from the spacer on the inner oven wall.
3. Mount the mounting plate half-fastened
on the spacer (3 bolts M5x10 serrated).
4. Put a layer of heat resistant sealant (644°F)
on the contact-surface.
5. Push the spacer on its place (1 bolt centre-
up !) against the inner oven-wall and
mount the 4 blolts half-fastened (M5x10
serrated).
6. Mount the 3 bolts on the inside and fasten
them (M5x18).
7. Remove the redundant sealant with a
cloth or the like.
8. Now fasten the 7 bolts at the rear.
2
4
ASSEMBLING THE BLOWERS
9
10
ASSEMBLING THE SHAFT TRANSIT SPACER.
5
6
8
9.
Carefully clean the blower shaft.
File away the damaging on the blower shaft
caused by the socket set-screw of the adjus-
tingring in. (this only applies when the old
shaft seal was from a previous model)
10. Put the blower motor on its position and
place the nuts. Not tight!! (M6 serrated
black).
