Page 33
Service Procedures
Service Manual Deli Multisserie form 9123560 rev. 02/2017
Notice: Do not touch the lamps with bare
hands. Use a clean cloth or paper tissues when
replacing the lamp. Remove any moisture with
alcohol or methylated spirits after the lamp
has cooled down.
1. Remove the plug from the wall socket.
2. Remove the 4 screws from the lamp holder.
Beware, the frame, glass and gasket will
come off at the same time.
3. Remove the lamp.
Push the lamp agains the spring to one side
of the lamp holder and pull it down.
4. Install a new halogen lamp (
120
V – 150 W).
First press one side of the lamp into one
connection point, then put the lamp pro-
perly in its place and have it spring into the
other connection point (as showed).
5. Make sure the lamp is properly clamped bet-
ween the two connection points.
6. Install the gasket, glass and frame.
7. Before fastening the screws completely,
move the glass to the middle of the frame.
It is the intension that the glass corners do
not touch the edge.
REPLACEMENT OF A LAMP
