Page 34
Service Procedures
Service Manual Deli Multisserie form 9123560 rev. 02/2017
DISASSEMBLING THE STEAM INJECTION PIPES AND JOINTS
1. Gain access to the heater compartment as-
described in a previous chapter.
2. Check if the pipes [229 and 230] are open.
3. Try to drill out the holes with a 19/64” drill
in case it is clogged with lime, or place new
ones. (Carbide tipped drills might be the
best choice, because lime can be like stone).
4. Check if the joints [227] in the top are open.
5. Try to drill out the holes with a 19/64” drill
in case it is clogged with lime, or place new
ones.
Exchanging the joints [227].
6. Open the service doors on the back.
7. Open the top of the unit. (9 screws)
8. Unscrew 7 screws M5x12 and 4 screws
M5x 30 at the top-backside.
9. Check if the glass controll panel and name
panel cannot fall. It should be locked up
behind the cover plates [559 and 563], see
arrow. In case of doubt, lock them with
tape or something
10. Remove the top plate.
1
6
4
2
8
7
9
