Page 39
Service Procedures
Service Manual Deli Multisserie form 9123560 rev. 02/2017
EXCHANGING THE ROTOR COLUMN AND CENTRAL SPRAYER PIPES
1. Remove all chicken racks and/or baskets.
2. Unscrew the horizontal sprayer pipe [224].
3. Unscrew 2 bolts M5 and remove the 2
mounting plates [215].
4. Bend the lock washer [851]open.
5. Unscrew the M22 nut [852]. Use a 32 mm
wrench or suitable pliers.
Hold the column [317] with a bar (the hand-
le of a hammer for example). Do this as
high as possible.
6. Lift the central sprayer pipe [216] and take
out the assembly. Be carefull with the cable
of the core probe!!
7. Remove the lower sprayer [212]. Slide down
the pipe below the middle ring, turn it out-
wards and slide the pipe out of the column.
8. Remove the 2 selftapping screws and take
out the teflon bearing [318].
Only if it
needs to be replaced!
!
9. Take the O-rings and the teflon washer from
the joint [219].
10. Check the joint for wear. Remove it in case
of wear.
Reverse the procedure to assemble but pay at-
tention to the following:
• Take a new teflon washer and O-rings on
the joint [219].
• Take a new lock washer.
• Bend the lock washer open with a screwdri-
ver or chisel. See picture.
• Clamp the lock washer with suitable pliers
• Mount the horizontal sprayer pipe so that
the sprayers point down in a ±25° forward
direction as shown. Use teflon tape on the
pipe thread.
1
3
2
1/4” BSPt
4
5
6
9
10
7
