Page 51
Service Procedures
Service Manual Deli Multisserie form 9123560 rev. 02/2017
Left door
middle door
right door
Step 2.
• Fully open the doorhandle and check the
clearance between the Locking pin and the
catch at the top and the bottom side. This
should be ± the same.
• Move the corresponding hinge to achieve
this.
Step 3.
In case this is ok then repeat this for
the middle door and the right door.
In case it is not possible to get clearance at
the bottom pin, then check the doorhandle
mechanism. There is probably some wear,
causing too much slack. Check this by pu-
shing up the lower pin. 1 mm is normal.
Adjusting the inner door.
Preface.
The inner door must “grap” with the magnet
holder [118] behind the finishing plate [153]
of the outer door.
In this way, the inner door will be “pulled”
around the doorgasket when the outer
door is beïng closed.
1. Check the distance between the glass and
the hinge profile. This must be < 1/32”
(< 1mm)
2. Check if the 2 bolts on the hinge side are
tighened.
3. Repeat #1 and 2 for the bolts of the magnet
holder .
Overview of hinges and catches.
0 mm !!
< 1 mm
Note that a washer is used under the top
hinge bolt, in case a door “stop” is mounted
Door stop
