Page 52
Service Procedures
Service Manual Deli Multisserie form 9123560 rev. 02/2017
6mm
5mm
Outer glass
Inner glass
2x
3mm bush
1x 3mm bush
1x 2mm bush
Mounting of glass
Mounting of the glass.
• The glass must never touch the metal! The-
refore, a ptfe collar bush is applied at each
bolt. 2 different sizes are available, 2mm
[109] and 3mm [110]. See drawing how to
use.
• Refer to the exploded views to see how
each door is assembled.
• The torque for all bolts, going through
these bushes is 8Nm (6lbf-ft).
Exchanging doorhandle parts.
1. Remove 2 nuts (metric 8). Hold the screw
with a “philips”.
Note that threadlocker has
been applied. An impact driver might be
useful.
2. Take out the finishing plate [153].
Note that
the handle profile [147] on the other side is
glued to the glass and will not fall.
3. Unscrew 4 screws, slide out both latch rods
and take out both drive plates.
4. Loosen the screw from the fixed doorhandle
above the lock construction profile [131] .
5. Unscrew 2 screws on the side of the handle.
6. Push out the bushes [815] and take out the
handle [130].
7. Turn the upper door handle away, unscrew 2
screws and take out the doorhandle assem-
bly [104]
8. Push out the pin [136] and take
out the top and bottom lever
[138 and 139].
Reverse the procedure to assemble.
Check / tighten the screws of the fixed door-
handles.
Put some tissue behind the drive plate to ease
the mounting and then slide the latch rod
in front of it.
1
2
3
5
7
8
4
Mounting
