Service Instructions
Page 81
Service Manual Deli Multisserie form 9123560 rev. 09/2017
9190562
9190561
9190559
9190560
Break out
HINGE REPAIR KIT 9190565
Mounting description
1. Take out the inner door.
2. Remove the top hinge.
3. Remove the outer door.
4. Remove the bottom hinge
5. Do this for all 3 doors.
6. Drill out the M5 rivet nuts.
7. Tick the remainings inwards the post.
8. Remove the square top plate.
9. Put the enforcement strip in the correspon-
ding door post.
10. Mount the hinges back with the M6 bolts.
Points of attention:
The welded nuts have to point to the center of
the unit. See top view detail.
In case it does not reach the bottom, caused by
the remainings of the rivet nuts, let it fall into the
post. This will usually move the rivet nuts out of
the way
Remarks:
9190559 has a slot at the bottom side, which is
necessary for the PT1000 sensor in that post.
Take care of the PT1000 wiring!
9190560 has 2 “nock-outs”. These need to be
removed just before placing next to the side post
sprayer pipe.
Since May 2011, serial number 100052917, M6 bolts are used to mount the door hinges.
In case in older units, the M5 screws don’t hold anymore, this kit can be used.
Take care of
PT1000 wiring
Top view detail
