DISPLAY PREMIUM MODEL
B1
B2
B3
B4
B5
B6
B7
B8
Service Manual Hot Deli HD3/4/5/7 form 9123549 rev.03/2017
PROGRAMMING INSTRUCTIONS
Page 11
Switch on
1. Keep keys B3 and B4 pressed
simultaneously for 2 seconds.
2. Switch on the lighting with
key B3.
3. Switch on the required IR
emitters with keys B1.
Switch off
1. Keep keys B3 and B5 pressed
simultaneously for 2 seconds.
Check set temperature
The temperature in the warmer is shown on the display B2 during use.
1. Press key B4 or B5 for a short time.
The set temperature will be shown on the display. The measured temperature in the warmer
will be shown again after 10 seconds.
Set the temperature
The temperature is set on 80°C and limited between 30°C and 90°C as standard.
1. Press key B4 or B5 for a short time. The set value will be shown on the display with a dot
behind the value.
2. Wait 5 seconds; you cannot immediately change the setting.
3. Set the required temperature with keys B4 and B5.
4. Wait until the display jumps back to the measured temperature in the warmer.
The adjustment has now been saved.
Topping up the steam tray
You hear a signal as soon as the steam tray requires topping up. Humidification will be
automatically switched off.
1. Press key B7 or B8 to stop the beep signal.
2. Fill the steam tray by three quarters (approx. 6,5 L.) with hot water to prevent large
temperature differences.
Humidification will restart automatically based on the previously set adjustment
after topping up. You do not have to set it again.
Summary of Contents for HOT DELI 3
Page 2: ...Service Manual Hot Deli HD3 4 5 7 form 9123549 rev 04 2017 Page 2 TABLE OF CONTENTS EMPTY PAGE...
Page 7: ...Service Manual Hot Deli HD3 4 5 7 form 9123549 rev 04 2017 Page 7 TABLE OF CONTENTS EMPTY PAGE...
Page 122: ...Service Manual Hot Deli HD3 4 5 7 form 9123549 rev 03 2017 Page 122 EMPTY PAGE...
Page 123: ...Service Manual Hot Deli HD3 4 5 7 form 9123549 rev 03 2017 Page 123 EMPTY PAGE...
