REMOVAL AND REPLACEMENT OF PARTS
Service Manual Hot Deli HD3/4/5/7 form 9123549 rev.03/2017
Page 14
1. Remove the left side panel and the cover
plate according prior procedure.
2. Remove the bolt that secures the electric
panel and remove this panel.
3. Cut the wiring of the blower.
4. Remove the bolts that secure the
clamping profiles on the blower and
remover the profiles.
5. Remove the blower by sliding this
towards yourself.
6. Reverse the procedure to install.
Note:
you have to connect the wiring again
with a butt splice.
BLOWER, LEFT HAND SIDE
1. Remove the left side panel and the cover
plate according prior procedure.
2. Disconnect the lead wires to the
contactor.
3. Push the locking tab down with a screw-
driver (see arrow) and lift out to remove
the contactor from the mounting brack-
et.
4. Reverse the procedure to install.
CONTACTOR
1. Remove the left side panel and the cover
plate according prior procedure.
2. Disconnect the wiring of the electronic
control.
3. Remove the 2 screws that secure the
control and remove the control.
4. Reverse the procedure to install.
WATER LEVEL CONTROL, ELECTRONIC
Summary of Contents for HOT DELI 3
Page 2: ...Service Manual Hot Deli HD3 4 5 7 form 9123549 rev 04 2017 Page 2 TABLE OF CONTENTS EMPTY PAGE...
Page 7: ...Service Manual Hot Deli HD3 4 5 7 form 9123549 rev 04 2017 Page 7 TABLE OF CONTENTS EMPTY PAGE...
Page 122: ...Service Manual Hot Deli HD3 4 5 7 form 9123549 rev 03 2017 Page 122 EMPTY PAGE...
Page 123: ...Service Manual Hot Deli HD3 4 5 7 form 9123549 rev 03 2017 Page 123 EMPTY PAGE...
