9
EN
Stand/Update: 25.11.2014
2.2
Obligations of the operator
All persons involved in commissioning, operation, maintenance and repair of
the CLAMP63 alignment clamp must:
• be correspondingly qualified for this work and
• strictly observe these operating instructions.
These operating instructions must always be kept at the place of use of the
alignment clamp and must be accessible to the operator at all times.
With regard to the intended use, please observe the accident prevention
reglations, environmental regulations and statutory rules, as well as the rel-
evant safety regulations and all local standards, laws and regulations.
2.3
Structural changes to the tool
The CLAMP63 alignment clamp must not be modified or altered in any way
without the approval of FRIATEC AG.
3. Assembly
• Undo the knurled screw and set the retaining section (1) to the desired
position. Make sure that the pin engages in the designated hole.
• Repeat so that all 4 retaining sections are set to the correct position for the
pipe size. Check that the respective dimensions indicated on the 4 retaining
sections (1) are the same.
• Tighten the knurled screw (2) finger-tight.
• Turn the rotary knob (3) anti-clockwise to open the alignment clamp.
CAUTION
Risk of crushing!
Careless assembly can result in hands or fingers becoming trapped!
