Friedrich CCW06B10B, Operating Instructions Manual

10

THROUGH-THE-WALL INSTALLATION INSTRUCTIONS - OPTIONAL

The case may be installed through-the-walll as optional.
Read completely, then follow step-by-step.
NOTE: Obtain all materials locally for mounting the air
conditioner through-the-wall.

Through-the-wall installation is not appropriate, if any of 
the side or top louvers of case is obstructed by the wall.

All side and top louvers in the case must project on the 
outdoor side of the wall.

The room side of the case must project into the room far 
enough to maximize the balance of the unit.

The case must be installed level from side to side and 
with a slight tilt from front to rear. Use a level, no more 
than a 1/2 bubble will be correct slant to the outside.

Lintel angle is required to support bricks or blocks 
above opening.

Flashing is required and should extend the length of the 
opening to ensure no inside cavity leakage occurs.

Building a wooden frame  is required when install the case
through-the-wall. The opening and dimension of wooden
frame is required as below.

IMPORTANT

Frame Max. Thickness

Inside Frame Width

Inside Frame Height

The Maximum
Wall thickness
8 9/10”(225mm)

Inside

Frame
Height

Frame

Thickness

8 9/10”( 225 mm)

1.Build a wooden frame into the wall opening and make 

sure fasten securely, which is suitable to the WALL 
OPENING REQUIREMENT.

2.Remove the air conditioner from the carton box and 

take off the chassis as window mounting installation.

3.Place the cabinet into the wooden frame, and lock the 

cabinet by the top rail hole and bottom chassis hole with
1” long wood screws as shown,  from inside to outside.

4. Assemble the two Support Bracket with Sill Angle 

Bracket to the cabinet against to the wooden frame as
window mounting installation instructions.

5. Assemble the chassis into the cabinet and fasten or 

lock it, as window mounting installation instructions.

Sill angle bracket

Support bracket

Bolt and
Locknut

NOTE: The allowed maximum wall thickness is less than
8 9/10”. Otherwise, the wall will block the air inlet of
outdoor side, it will effect the normally operation of unit.

20”( 508 mm)

15-1/5”(385 mm)

Inside

Frame

Width