En-4
Fig. 4 Remote Control Unit
C
SLEEP button
D
MASTER CONTROL button
E
SET TEMP./SET TIME buttons (
)
F
Signal Transmitter
G
TIMER button
H
FAN CONTROL button
I
START/STOP button
J
AIR FLOW DIRECTION
VERTICAL SET button
K
AIR FLOW DIRECTION
VERTICAL SWING button
L
AIR FLOW DIRECTION
HORIZONTAL SET button
M
AIR FLOW DIRECTION
HORIZONTAL SWING button
N
TIME ADJUST button
O
ACL button
Rear side (Fig. 5)
P
TEST RUN
●
Touch the two metal contacts with a me-
tallic object to send the signal to perform
a test run.
●
Perform a test run only when installing the
air conditioner. If the signal to perform a
test run is received during normal opera-
tion, the air conditioner’s thermostat will
malfunction.
●
If the signal to perform a test run is re-
ceived during normal operation, the unit
will switch to the test operation mode and
the indoor unit’s OPERATION and TIMER
indicator lamps will flash simultaneously.
●
To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
Q
Remote Control Unit Display (Fig. 6)
R
Transmit Indicator
S
Clock Display
T
Operating Mode Display
U
T imer Mode Display
V
Fan Speed Display
W
Temperature Set Display
X
T imer Set Indicator
Y
Temperature Set Indicator
Fig. 1 Indoor Unit
1
Operating Control Panel (Fig. 2)
2
MANUAL AUTO button
3
Remote Control Signal Receiver
4
OPERATION Indicator Lamp (red)
5
TIMER Indicator Lamp (green)
6
SWING Indicator Lamp (orange)
(VERTICAL SWING)
7
SWING Indicator Lamp (orange)
(HORIZONTAL SWING)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See page 16 Auto Restart).
8
Intake Grille (Fig. 3)
9
Air Filter
0
UP/DOWN Air Direction Flaps
A
RIGHT/LEFT Air Direction Louvers
(behind UP/DOWN Air Direction Flaps)
B
Drain Hose
9359944072-01_OM_en.p65
1/21/10, 1:50 PM
4
