31
CARE & CLEANING
Care and cleaning tips
Part
Cleaning Agents
Tips and Precautions
Interior &
Door Liners
•
Soap and water
•
Baking soda and
water
•
Use two (2) tablespoons of baking soda in one (1) quart of warm water.
•
Be sure to wring excess water out of sponge or cloth before cleaning
around controls, light bulb or any electrical part.
Door
Gaskets
•
Soap and water
•
Wipe gaskets with a clean soft cloth.
Drawers &
Bins
•
Soap and water
•
Use a soft cloth to clean drawer runners and tracks.
•
Do not wash any removable items (bins, drawers, etc.) in dishwasher.
Glass
Shelves
•
Soap and water
•
Glass cleaner
•
Mild liquid sprays
•
Allow glass to warm to room temperature before immersing in warm water.
Toe Grille
•
Soap and water
•
Mild liquid sprays
•
Vacuum
•
Remove toe grille (see Installation Instructions).
•
Vacuum both sides and wipe with sudsy cloth or sponge. Rinse and dry.
Exterior &
Handles
•
Soap and water
•
Non abrasive glass
cleaner
•
Do not use commercial household cleaners containing ammonia, bleach or
alcohol to clean handles.
•
Use a soft cloth to clean smooth handles.
•
Do not use a dry cloth to clean smooth doors.
Exterior &
Handles
(Stainless
Steel Models
Only)
•
Soap and water
•
Stainless steel
cleaners
•
Never use CHLORIDE or cleaners with bleach to clean stainless steel.
•
Clean stainless steel front and handles with non-abrasive soapy water and a
dishcloth. Rinse with clean water and a soft cloth.
•
Use a non-abrasive stainless steel
cleaner. These cleaners can be purchased
at most home improvement or major department stores. Always follow
manufacturer’s instruction. Do not use household cleaners containing
ammonia or bleach.
•
NOTE: Always clean, wipe and dry with grain to prevent scratching.
•
Wash the rest of the cabinet with warm water and mild liquid detergent.
Rinse well and wipe dry with a clean soft cloth.
Ice Chute Extension
The ice chute extension is
designed to better direct ice
flow into containers.
Removing the Ice
Chute Extension For
Cleaning
1 Turn the refrigerator
off using the button
on the control
panel (refer to the
“Controls” section of
this Manual).
2
Press inward firmly on
the front of the chute
and pull down.
3 Turn your refrigerator
back on.
Push Upward Until The
Extension Snaps In Place
Pull Down
Press Here
Firmly
Installing the Ice
Chute Extension
1 Turn the refrigerator off
using the button on the
control panel (refer to
the “Controls” section of
this Manual).
2 Align the extension with
the ice chute so that the
snap clips are just inside
the front edge of the chute.
3 Push upward until the extension snaps into place.
4 Turn your refrigerator back on.
