16
Setting the Clock
The CLOCK
pad is used to set the clock. The clock may be
set for 12 or 24 hour time of day operation. The clock has been
preset at the factory for the 12 hour operation. When the range is
first plugged in, or when the power supply to the range has been
interrupted, the timer in the display will flash with "PF" (power
failure, See Fig. 1).
To set the clock (example below for 1:30):
1.
Press
. "CLO" will appear in the display (Fig. 2).
2.
Press
pads to set the time of day to 1:30 (Fig.
3). "CLO" will appear in the display. Press
. "CLO" will
disappear and the clock will start (Fig. 4).
Changing between 12 or 24 hour time of day display:
1.
Press and hold
for 6 seconds (Fig. 3). While holding the
pad down, the current time of day will remain and "CLO" will
disappear from the display (Fig. 4). CONTINUE holding the pad
until the a beep is heard.
2.
The display will show either "12:00" (Fig. 5) or "24:00" (Fig. 6).
3.
Press
to switch between the 12 and 24 hour time of day
display. The display will show either "12:00" (Fig. 5) or "24:00"
(Fig. 6).
4.
Press
to accept the change or press
to reject the
change.
5.
Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 0:00 through 23:59 hours.
for 6 seconds
or
INSTRUCTIONS
PRESS
DISPLAY
Setting Oven Controls
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
