14
Before Setting Oven Controls
Refer to the Electronic Oven Control Guide for oven settings.
Setting Oven Controls
4
3
2
1
Removing and Replacing Oven
Racks
To remove
, pull the rack forward until it
stops. Lift up front of rack and slide out.
To replace
, fit the rack onto the guides
on the oven walls. Tilt the front of the
rack upward and slide the rack back into
place.
Oven Vent Location -Models with
Ceramic Glass Cooktop
The oven vent is located
at right side of the
front panel
and visible when the oven door
is open. When the oven is on, hot air is
released through the vents. This venting is
necessary for proper air circulation in the
oven and good baking results.
RECOMMENDED RACK POSITIONS FOR
BROILING, BAKING & ROASTING
Food
Rack position
Broiling meats, chicken or fish
3 or 4
Cookies, cakes, pies, biscuits &muffins
1 rack
2 or 3
Multiple racks
2 & 4
Frozen pies, angel food cake, yeast, bread,
1 or 2
casseroles, small cuts of meat or poultry
Turkey, roast or ham
1
Note: Always use caution when removing food.
Oven Vent Location -Models
with Coil Elements
The oven is vented
through the
right rear coil element
. When
the oven is on, warm air is released
through the vent. This venting is
necessary for proper air circulation
in the oven and good baking
results. DO NOT block the vent.
Doing so may cause cooking
failures, fire or damage to the
appliance.
OVEN VENT
Arranging Oven Racks
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE OVEN). Always use oven
mitts when the oven is hot.
OVEN VENT
This range has a fan that will turn “ON” and “OFF” by itself to keep the electronics cool. It may
continue to run after the range has been turned “OFF”, but may also stop immediately and then turn “ON” after a
while.
Rack
positions
Figure 1
