17
Care & Cleaning
Lock in normal
position
Figure 3
Lock engaged
for door removal
Figure 1
HINGE SLOT
Door removed from the range
Figure 2
Care and Cleaning of Stainless Steel
(Stainless Steel models only)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are
required
for maintaining the appearance of stainless parts. Please refer to the table provided
at the beginning of the
General Care & Cleaning
section in this Use & Care Guide.
Removing and Replacing the Oven Door
The door is heavy. For safe, temporary storage, lay the door flat with the inside
of the door facing down.
To Remove Oven Door:
1. Open the door to the fully opened position.
2. Pull up the lock located on both hinge supports and engage it in the hinge levers
(Figure 1). You may have to apply a little downward pressure on the door to pull the
locks fully over the hooks.
3. Grab the door by the sides, pull the bottom of the door up and toward you to disengage
the hinge supports. Keep pulling the bottom of the door toward you while rotating the top
of the door toward the range to completely disengage the hinge levers (Figure 2).
4. To clean oven door, follow the instructions provided in the
General Care & Cleaning
table.
To Replace Oven Door:
1. Grab the door by the sides; place the hinge supports in the hinge slots. Open the door to
the fully opened position.
2. Disengage the lock from the hinge levers on both sides (Figure 3).
Note: Make sure the hinge supports are fully engaged before unlocking the hinge levers.
3. Close the oven door.
Special Door Care Instructions -
Most oven doors contain glass that can break.
Read the following recommendations:
1.
Do not close the oven door until all the oven racks are fully in place.
2.
Do not hit the glass with pots, pans, or any other object.
3.
Scratching, hitting, jarring or stressing the glass may weaken its structure causing an
increased risk of breakage at a later time.
