13
CAUTION
Wear gloves and safety goggles. Use extreme CAUTION when installing these
handles.
NOTE
All set screws should be tightened so the screw is below the surface of the handle.
The handles should be drawn tight to doors/drawer with no gaps. Opening the op-
posite door while tightening the Allen screw makes installation easier.
The door handle may loosen over time or if it was installed improperly. If this hap-
pens, tighten the set screws on the handles.
Door Handle Mounting
Instructions for Frigidaire
Gallery
1. Remove handles from
carton and any other
protective packaging.
2. Position fresh food handle
end caps over upper
and lower pre-installed
shoulder bolts (A) that
are fastened into door,
ensuring the holes for
the set screws are facing
towards the opposite door.
3. While holding handle
firmly against door, fasten
upper and lower Allen set
screws (B) with supplied
Allen wrench.
4. Repeat steps 2 and 3 to
install opposite handle.
Ensure the holes for the
set screws are facing
towards the first door.
5. Position freezer/Custom-Flex
TM
Temp Drawer handle end caps
over left and right pre-installed
shoulder bolts (A) that are
fastened to the door, ensuring
the holes for the set screws are
facing down.
6. While holding handle
firmly against door,
loosely tighten right
Allen set screw (B) with
supplied Allen wrench
until there is no gap
between handle and door.
7. Still holding the handle firmly
to the door, firmly tighten
left Allen set screw (B) with
supplied Allen wrench.
8. Return to the right Allen
set screw (B) and firmly
tighten with supplied
Allen wrench.
Mounting Freezer
Custom-Flex
TM
Temp Drawer Handle
Mounting Refrigerator Handles
DOOR HANDLE INSTALLATION
NOTE
When tightening the Allen set screws, it is impera-
tive that force be applied to the longer arm of the
Allen wrench supplied in the handle packaging.