Frigidaire A19644502, Use & Care Manual

6



NOTE

If your appliance is placed with the door 

hinge side against a wall, you may have 

to allow additional space for the handle 

so the door can be opened wider.

This Use & Care Manual provides general 

operating instructions for your model. Use 

the appliance only as instructed in this Use 

& Care Manual. Before starting the appli-

ance, follow these important first steps.

Installation

Installation clearances

Allow the following clearances for ease 

of installation, proper air circulation, and 

plumbing and electrical connections:
Sides, Top & Back  

3

 in. (75 mm)

Guidelines for final positioning of  

your appliance:

•  All 4 corners of the cabinet must rest 

firmly on the floor.

•  The cabinet should be level at the 

front and rear.

•  The door should be level.

WARNING

DO NOT install the appliance where 

the temperature will drop below 0°F 

(-18°C) or rise above 110°F (43°C). The 

compressor will not be able to maintain 

proper temperatures inside the unit.

Location

•  Choose a place that is near a ground-

ed electrical outlet. Do Not use an 

extension cord or an adapter plug.

•  If possible, place the appliance out of 

direct sunlight and away from the range, 

dishwasher or other heat sources.

•  Install the appliance on a floor that is 

level and strong enough to support a 

fully loaded appliance.

3" (75 mm) Air Space

3"

(75 mm)

3" 

(75 mm)

3"

(75 mm)

INSTALLATION

CAUTION

Do not block the lower front of your ap-

pliance. Sufficient air circulation is essen-

tial to operate your appliance properly.

Shorten

Lengthen



NOTE

It is 

VERY IMPORTANT

 for your appli-

ance  to be level in order to function 

properly. If the unit is not leveled during 

installation, the door may be misaligned 

and not close or seal properly, causing 

cooling, frost or moisture problems.

Leveling  

The appliance must have all bottom 

corners resting firmly on a solid floor. The 

floor must be strong enough to support a 

fully loaded unit.  

To level: 

Adjust the bottom feet by 

turning counterclockwise to shorten and 

clockwise to lengthen. Use a carpenter’s 

level to level the appliance from front to 

back. Adjust the leveling feet in front, 

½

bubble higher, so the door closes easily.