7
OPERATING INSTRUCTIONS
This manual covers many models and not all cycles, options, or features listed are available on every model. Console shown above
for reference only. Your model may differ.
Turn the cycle selector in either direction to the cycle
desired.
Once a cycle is running, turning the selector knob to
another selection will not change the cycle. If cycle
selection change is attempted after the cycle starts, the
indicator lights will fl ash and a signal will beep, but the
original cycle will continue.
Cycle Selection
Í
NOTE
To change the cycle selection once the cycle has
begun, push in and hold the cycle selector knob to
cancel the current cycle, make the new selection and
push in the selector knob again to restart the dryer.
Follow the fabric care label
instructions on items
to be dried.
For best results
Auto Dry Cycles
Auto Dry cycles take the guesswork out of selecting the
correct drying time for each load. Moisture sensing bars
at the back of the dryer drum sense the moisture level of
the load as it tumbles through the heated air. With Auto
Dry cycles, the load will automatically be dried at the
selected temperature to the desired dryness level. Auto
Dry cycles save time and energy and protect fabrics.
The estimated drying time will be displayed for about 5
minutes. Then the outside of the display will light up in a
circular track to indicate the drying time is automatically
being determined by the sensors. When the load has
reached the selected dryness level, it will continue to
tumble during a cool down period. This helps reduce
wrinkling and makes items easier to handle during
unloading.
1. initial
2. calculating
3. estimated
Drying time varies depending on size and dampness of
load and fabric type. If the load is too small or almost
dry, the moisture sensing bars may not detect enough
moisture to continue the cycle and the cycle may end
after a few minutes. If this occurs, select a Timed Dry
cycle.
Room temperature and humidity, type of installation and
electrical voltage or gas pressure can also affect drying
time.
