Frigidaire ATF705X, User Manual

16

Installation

 WARNING!

Water inlet

Do not use the hose from your previous appliance to connect to 
the water supply.

Do not place the inlet hose down-
wards. Angle the hose to the left 
or right depending on the position 
of your water tap.

1.  Set the hose correctly by loosening the ring nut. After 

positioning the inlet hose, be sure to tighten the ring nut 
again to prevent water leaks.

2.  Connect the hose to a tap with 

a 3/4” thread. Always use the 
hose supplied with the ap-
pliance. The inlet hose must 
not be lengthened. If it is too 
short and you do not wish to 
move the tap, you will have to 
purchase a new, longer hose 
specially designed for this type 
of use.

Water drainage

The end of the drain hose can be positioned in three ways:

Hooked over the edge of a sink us-
ing the plastic hose guide supplied 
with the appliance.

 In this case, 

make sure the end cannot come 
unhooked when the machine is 
emptying. This could be done by 
tying it to the tap with a piece of 
string or attaching it to the wall.

In a sink drain pipe branch.

 This 

branch must be above the trap 
so that the bend is at least 60 cm 
above the ground.

Directly into a drain pipe

 at a height of not less than 60 cm 

and not more than 90 cm. The end of the drain hose must 

always be 

ventilated

, i.e. the inside 

diameter of the drain pipe must be 
larger than the outside diameter of 
the drain hose.

The drain hose must not be kinked.