6
Control Panel, continued
5
Select Button
By pressing this button you can confi rm or delete the options selected by means of button
4
.
6
Soil Level Button
By pressing this option you can select or delete one of the following soil level:
• Quick:
By selecting this option the wash duration decreases. The display will show the
shorted washing time. To be used for lightly soiled laundry only. Recommended for smaller
loads (for more details see «Programme table»).
• Daily:
By selecting this button the wash duration decreases. To be used for normally soiled
laundry.
• Heavy:
By selecting this option the wash duration increases.
7
Cancel/Reset Button
Press this button to stop the wash programme.
8
Start/Pause Button
Press this button to start, pause or restart a wash programme.
9
Door Lock Pilot Light
and Programme
Phase Pilot Lights
Door Lock:
• Light on: The door cannot be opened.
• Light blinking: The door lock is releasing. The appliance has been probably set to pause.
• Light off: The door can be opened.
Note
Do not try to force the door open when
Door Lock
light is on.
The following pilot lights indicate which wash phase the appliance is carrying out:
Wash:
During the wash phase.
Rinse:
When the appliance is rinsing.
Final Spin:
When the appliance is spinning.
10
Display
The display shows the following information:
• The duration of the selected programme:
After selecting a programme the duration of the
selected programme appears on the display.
• Select the delayed start by pressing the button 11.
Press this button to select the required
delay. The selected delay time value will appear on the display for few seconds, then the
duration of the programme will appear again. You must select this option after you have
set the programme and before you press the button
8
.
• Message
“
PAU
”
(PAUSE):
It is displayed alternately with the estimated time remaining when
the cycle is paused.
• Message
“
LOC
”
(LOCK):
It is displayed alternately with the estimated cycle time when you
lock the controls.
• If you try to start the programme and the door is open, the message “
DR
”
(DOOR)
is dis-
played.
• Message
“
PF
”
(POWER FAIL):
It is displayed alternately with Message “
PAU
” to indicate that a
power supply break has occurred and the appliance is not operating. Press the button
8
to
restart the wash programme.
11
Delay Start Button
By means of this buttons, the wash programme can be delayed from 30 min - 60 min - 90
min, 2 hours and then by 1 hour up to a maximum of 14 hours.
Summary of Contents for ATF705X
Page 18: ...18 Notes ...
