29
CARE & CLEANING
Cleaning recommendation table
Surface type
Recommendation
•
Control knobs
•
Painted body parts
•
Painted decorative trim
•
Aluminum (trim pieces) & vinyl
Use hot, soapy water and a cloth. Dry with a clean cloth.
For general cleaning
, use hot, soapy water and a cloth.
For
more difficult soils and built-up grease
, apply a liquid detergent
directly onto the soil. Leave on soil for 30 to 60 minutes. Rinse with
a damp cloth and dry.
Do not
use abrasive cleaners on any of these
materials; they can scratch. To remove control knobs, turn to the OFF
position; grasp firmly and pull straight off the shaft. To replace knobs
after cleaning, line up the flat sides of both the knob and the shaft;
then push the knob into place.
•
Control panel
•
Decorative trim
(some models)
Before cleaning the control panel,
turn all controls to OFF and
remove the control knobs (some models). Set the oven lock feature
before cleaning (some models). To remove knobs, pull knob straight
off the shaft. Clean using hot, soapy water and a dishcloth. Rinse with
a clean water using a dishcloth. Be sure to squeeze excess water from
the cloth before wiping the panel; especially when wiping around the
controls. Excess water in or around the controls may cause damage to
the appliance. To replace knobs after cleaning, line up the flat sides of
both the knob and the shaft; then push the knob into place.
•
Easy Care™ Stainless
Steel
(some models)
If your range finish is
Easy Care™ Stainless Steel
(some models),
clean the stainless with warm soapy water using a clean sponge or
cloth. Rinse with clean water and dry with a soft clean cloth.
DO NOT
use
ANY
store bought cleaners like Stainless Steel cleaners or any
other types of cleaners containing any abrasive, chlorides, chlorines
or ammonia. It is recommended to use mild dish soap and water or a
50/50 solution of water and vinegar.
•
Door liner & body parts
•
Porcelain enamel broiler pan and broiler
pan insert
(some models)
Gentle scouring with a soapy scouring pad will remove most spots.
Rinse with a 1:1 solution of clear water and ammonia.
If necessary
,
cover difficult spots with an ammonia-soaked paper towel for 30 to
40 minutes. Rinse with clean water and a damp cloth, and then scrub
with a soap-filled scouring pad. Rinse and wipe dry with a clean cloth.
Remove all cleaners or the porcelain may become damaged during
future heating.
Do not
use spray oven cleaners on the cooktop.
•
Oven racks
Oven racks must be removed from oven before starting
self-clean cycle.
Clean by using a mild, abrasive cleaner following
manufacturer’s instructions. Rinse with clean water and dry.
•
Oven door
Use soap & water to thoroughly clean the top, sides and front of the
oven door. Rinse well. You may use a glass cleaner on the outside
glass of the oven door.
Do not
immerse the door in water.
Do not
spray or allow water or the glass cleaner to enter the door
vents.
Do not use oven cleaners, cleaning powders or any harsh
abrasive cleaning materials on the outside of the oven door.
Do not
clean the oven door gasket. On self-cleaning models the oven door
gasket is made of a woven material which is essential for a good seal.
Care should be taken not to rub, damage or remove this gasket.
•
Ceramic cooktop
Refer to “Cooktop cleaning” and “Cooktop maintenance” in the
Care
& Cleaning
section.
Summary of Contents for CGEF3039RF
Page 35: ...35 NOTES ...