41
Troubleshooting
Before You Call For Service…
“SENSOR ERROR” appears in
the display?
When using a Sensor feature, the door
was opened before steam could be
detected. Do not open door until steam
is sensed and time is shown counting
down on display.
Steam was not detected in maximum
amount of time. Use Cook Time to heat
for more time.
Y
ou hear an unusual,
low-tone beep?
You have tried to start the Reminder
without a valid time of day. Start over
and enter a valid time of day.
You have tried to start the Auto Night
Light without a valid time of day entered
for the on-time and off-time. Start over
and enter a valid time of day.
You have tried to turn the turntable on
when the probe is in use. The turntable
will not operate when the probe is in use.
You have tried to change the power level
when it is not allowed. Many of the oven’s
features are preset and cannot be changed.
T
hings That Are Normal
•
Steam or vapor escaping from around
the door.
•
Light reflection around door or outer
case.
•
Dimming oven light and change in the
blower sound at power levels other
than high.
•
Dull thumping sound while oven is
operating.
•
TV-radio interference might be noticed
while using the microwave. Similar to the
interference caused by other small
appliances, it does not indicate a problem
with the microwave. Plug the microwave
into a different electrical circuit, move the
radio or TV as far away from the microwave
as possible, or check the position and
signal of the TV/radio antenna.
49-401431v03 4/26/01 2:45 PM Page 41