29
SETTING OVEN CONTROLS
3.
Once the door is closed the time of day will be visible
along with the selected clean time and the door lock
icon will be blinking in the display.
4.
During the clean cycle the time of day remains in the
display and the time remaining in the clean cycle will
also be active.(
)
5.
When the clean cycle ends the oven will be too hot for
the door to unlock until the oven cools to a safe temper-
ature. This may take up to an hour. During this time the
display will show
Hot
along with the door lock icon.
6.
At this point
CLn
will appear in the display and the lock
icon will blink to signal the end of the clean cycle with a
chime. The internal oven temperature will still be hot
enough to cause burns.
Caution:
Be careful when opening and stand to the side to
allow any steam and heat to escape.
Note:
Once the clean cycle ends the oven will not be
available for another clean for 4 hours.
To cancel a self clean before it ends:
Turn both the oven selector knob and the oven temperature
knob to the
OFF
position.
Figure 33: Clean cycle in progress
Figure 34: Hot oven after clean with door still locked
Figure 35: Clean lock icon blinks as door unlocks