23
1 - Remove the package base
Two people are required to remove the package base.
Carefully tilt the refrigerator for one side and breaks the side of the base to
remove it.
Tilt the refrigerator again to the other side and remove the rest of the base.
Remove the compressor pad which is the back of the refrigerator and all
foams and adhesive tapes of shelves and/or drawers.
2 – Choose the installation place
Respect the minimum distances between the refrigerator and the walls: on
top: 15 cm / side: 10 cm / back 15 cm.
Do not install the refrigerator outdoors or under the direct incidence of
sunlight.
Avoid placing the refrigerator next to chemicals or heat sources (stoves,
ovens, etc.), and areas with frequent water handling (tank, sink).
3 – Level the refrigerator
Close the refrigerator door.
Turn the leveling leg until all rest firmly on the floor. If necessary, tilt the
refrigerator carefully during leveling.
Avoid the refrigerator be tilted to one side or forward. The only inclination
allowed is back, to facilitate the doors closing.
Whenever moving the refrigerator will need to repeat the leveling process.
Whenever moving the refrigerator, it’s necessary repeat the leveling process.
Leveling is important because it prevents swinging movements, vibration and
problems with your refrigerator.
Do not use different leveling legs from the original ones.
Installation
Summary of Contents for DF35A
Page 34: ...34 Notes ...
Page 35: ...35 Notes ...
Page 36: ...www electrolux com A05170301 A G0010259 003 Jan 16 ...