Frigidaire EFMIS9000, Use & Care Manual

INSTALLING YOUR BEVERAGE CENTER

Electrical Requirement

• 

Make sure there is a suitable power outlet (115 volts, 15 amps outlet) with 

proper grounding to power the Beverage Center.

• 

Avoid the use of three prong adapters or cutting off the third grounding

prong in order to accommodate a two prong outlet. This is a dangerous

practice since it provides no effective grounding for the Beverage Center

and may result in shock hazard.

• 

Do not install your Beverage Center in any location not properly insulated

or heated (e.g., garage etc.). Your Beverage Center was not designed to

operate in ambient temperature settings below 55°F Fahrenheit.

• 

Select a suitable location for the Beverage Center on a hard even surface

away from direct sunlight or heat source (e.g., radiators, baseboard heaters, 

cooking appliances, etc.). Any floor unevenness should be corrected with 

the leveling legs located on the front and rear bottom corners of the 

Beverage Center.

• 

Your Beverage Center is designed for freestanding installation only. It is not 

designed for built-in application.

Note:

 This unit is for indoor use only.

• 

Avoid the use of an extension cord because of potential safety hazards 

under certain conditions. If it is necessary to use an extension cord, use only 

a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot 

outlet that will accept the plug. The marked rating of the extension cord 

must be equal to or greater than the electrical rating of the appliance.

Installation Limitations

Use of Extension Cord

WARNING: 

ELECTRICAL REQUIREMENT - SHOCK HAZARD

6