8
Auto
Temp
Auto
Temp
Air Conditioner Features
(continued)
Note: In this “MODE” the selected temperature will increase by
2 degrees F 30 minutes after the mode is selected. The
temperature will then increase by another 2 degrees F after an
additional 30 minutes. This new temperature will be maintained
for 7 hours before it returns to the originally selected
temperature. This ends the “Sleep” MODE and the unit will
continue to operate as originally programmed. The “Sleep”
MODE program can be cancelled at any time during operation
by again pressing the “Sleep” button.
DO THIS:
PRESS SLEEP
BUTTON
YOU WILL SEE:
SLEEP FEATURE:
LIGHT On
Auto
Temp
Auto
Temp
CHECK FILTER FEATURE:
YOU WILL SEE:
LIGHT On
CLEAN AIR FEATURE
(on some models):
LIGHT On
YOU WILL SEE:
DO THIS:
PRESS CLEAN
AIR BUTTON
Note: This feature is a reminder to clean the Air Filter (See
Care and Cleaning) for more efficient operation. The LED (light)
will illuminate after 250 hours of operation. To reset after
cleaning the filter, press the “Check Filter” button and the light
will go off.
Note: When this feature is “ON”, the electronic air purifier is
energized to remove pollen and impurities from the air. To cancel
this feature, press the Clean Air button (the LIGHT will turn
off).
Note: This feature can be activated on the unit touchpad ONLY.
Auto
Temp
Auto
Temp
SZ000705(En)-YaoKong
09/2/2005, 2:20 PM
8
